CVE-2026-130621- Time-of-check time-of-use race condition in the port selection in AWS efs-utils
Bulletin ID: 2026-186-AWS
Scope: AWS
Content Type: Important (requires attention)
Publication Date: 11/17/2026 11:00 AM PST
Description:
AWS efs-utils is an open source mount helper and set of utilities for mounting Amazon EFS file systems, and is bundled in the Amazon EFS CSI Driver and the Amazon EKS EFS CSI add-on.
We identified CVE-2026-130621, an issue in the port selection in AWS efs-utils (amazon-efs-utils) before v3.3.5, which is also bundled in the Amazon EFS CSI Driver before v3.5.4 and the Amazon EKS EFS CSI add-on before v3.5.4-eksbuild.1. When two mounts start at the same time on one host, they can select the same local port, so one mount can be served by the other mount's tunnel (stunnel or proxy). The impact is limited to access between workloads on the same host at the same time.
The issue grants no access beyond what the host already had. The host owner configured every mount involved, with credentials and access points they control, against file systems that already allowed that host access. No other party is involved unless the host owner set up a cross-account mount. The issue doesn't reveal the other mount's IAM credentials or TLS session keys.
Impacted versions:
- amazon-efs-utils < v3.3.5
- aws-efs-csi-driver < v3.5.4
Resolution:
This issue has been addressed in amazon-efs-utils versions v3.3.5 and aws-efs-csi-driver v3.5.4 (EKS add-on: v3.5.4-eksbuild.1). We recommend upgrading to the latest version and ensuring any forked or derivative code is patched to incorporate the new fixes.
Workarounds:
There is no workaround that fully addresses this issue. We recommend upgrading to the versions listed above. Until you can upgrade, the following steps reduce the risk:
- Widen the local port range used for mounts to make it less likely that two mounts select the same port. In /etc/amazon/efs/efs-utils.conf, under [mount], increase the range between port_range_lower_bound and port_range_upper_bound (default 20049-21049), for example to 20049-30049. Keep the range below the start of the system's ephemeral port range (see /proc/sys/net/ipv4/ip_local_port_range, typically 32768).
- Avoid starting mounts at the same time on one host. For the Amazon EFS CSI Driver, set --max-inflight-mount-calls-opt-in=true and --max-inflight-mount-calls=1 on the node DaemonSet so that each node runs one mount operation at a time. This can increase pod start time on nodes that mount many volumes.
References:
Please email aws-security@amazon.com with any s ecurity questions or concerns.